Home » SWITCH 642-813 Q&As » Section 6 - Mix Practice Q&As » 642-813 Q&A – Mix Practice Questions (1-5)

642-813 Q&A – Mix Practice Questions (1-5)

Section 6 – Mix Practice Questions

You have just created a new VLAN on your network for inter-VLAN routing. What is one step that you should include in your VLAN-based implementation and verification plan?
A. Verify that different native VLANs exist between two switches for security purposes.
B. Verify that the switch is configured to allow for trunking on the switch ports.
C. Verify that each switch port has the proper IP address space assigned to it for the new VLAN.
D. Verify that the VLAN virtual interface has been correctly created and enabled.
Answer: D

What is the objective of the Cisco Compatible Extensions program?
A. to provide access to proprietary Cisco IOS software code in order to expand the number of vendors writing wireless code
B. to provide Cisco engineers with the opportunity to certify that any wireless devices that are made by third parties are compatible with Cisco wireless products
C. to provide customers with a broad range of WLAN client devices that have been tested for interoperability with Cisco Aironet innovations
D. to provide third parties with Cisco hardware in order to encourage the development of radical innovation in the area of wireless
Answer: C

You are planning a new VLAN-based network solution. What is one item you should consider when creating your implementation plan as it concerns VLANs?
A. generic router and switch configuration parameters
B. end-to-end test plan after all components have been installed and configured
C. administrator assignments
D. rollback plan
Answer: D

Which command alone will disable trunking on a Layer 2 switch port?
A. no switchport trunk native vlan vlan-id
B. switchport nonegotiate
C. no switchport mode dynamic desirable
D. switchport mode access
Answer: D

Which statement is true regarding the Port Aggregation Protocol?
A. Configuration changes made on the port-channel interface apply to all physical ports assigned to the portchannel interface.
B. Configuration changes made on a physical port that is a member of a port-channel interface apply to the port-channel interface.
C. Configuration changes are not permitted with Port Aggregation Protocol; instead, the standardized Link Aggregation Control Protocol should be used if configuration changes are required.
D. The physical port must first be disassociated from the port-channel interface before any configuration changes can be made.
Answer: A

One thought on “642-813 Q&A – Mix Practice Questions (1-5)

Comments are closed.