Section 6 – Mix Practice Questions
QUESTION NO: 71
Which of the following is not information provided from an IP phone to a Catalyst switch using CDP? (Select the best answer.)
A. device PoE requirements
B. device IP address
C. device voice VLAN ID
D. device platform
Answer: C
QUESTION NO: 72
A Cisco Aironet Wireless LAN Adapter CB21AG is inserted into a Pass4sure user’s PC cardbus slot. Both the green status LED and the amber activity LED are blinking slowly. What is the condition of the adapter?
A. The adapter is scanning for the wireless network for which it is configured.
B. The adapter is in power save mode.
C. The adapter is transmitting or receiving data while associated to an access point or another client.
D. The adapter is not receiving power.
E. The adapter is associated to an access point or another client.
Answer: E
QUESTION NO: 73
On an Aironet card, LED 0 and LED 1 are blinking alternately. What does this indicate?
A. The Aironet card is in power save mode.
B. The Aironet card is looking for a network association.
C. The Aironet card is joined to a network, but there is no network activity.
D. The Aironet card is joined to a network, and there is network activity.
Answer: B
QUESTION NO: 74
Cat6500(config)# router ospf 1
Cat6500(config-router)# network 0.0.0.0 255.255.255.255 area 0
Cat6500(config-router)# nsf Cat6500(config-router)#end
Refer to the exhibit. The configuration is used to enable nonstop forwarding for OSPF on a Catalyst 6500 Series Switch with redundant supervisor engines.
The default CEF configuration is unchanged. After testing, user traffic is interrupted and NSF is not operational. What is the most likely reason?
A. CEF was not properly configured.
B. OSPF was not properly configured for graceful restart.
C. Stateful switchover was not correctly configured.
D. NSF for OSPF is only supported in area 0.
Answer: C
QUESTION NO: 75
Refer to the exhibit. Which statement is true about the output?
A. The port on switch CAT1 is forwarding and sending BPDUs correctly.
B. The port on switch CAT1 is blocking and sending BPDUs correctly.
C. The port on switch CAT2 is forwarding and receiving BPDUs correctly.
D. The port on switch CAT2 is blocking and sending BPDUs correctly.
E. The port on switch CAT3 is forwarding and receiving BPDUs correctly.
F. The port on switch CAT3 is forwarding, sending, and receiving BPDUs correctly.
Answer: A
