Home » SWITCH 642-813 Q&As » Section 6 - Mix Practice Q&As » 642-813 Q&A – Mix Practice Questions (91-95)

642-813 Q&A – Mix Practice Questions (91-95)

Section 6 – Mix Practice Questions

QUESTION NO: 91
Which two of the following steps are necessary to configure inter-VLAN routing between multilayer switches? (Choose two.)
A. Configure a dynamic routing protocol.
B. Configure SVI interfaces with IP addresses and subnet masks.
C. Configure switch ports with network addresses.
D. Configure switch ports with the autostate exclude command.
E. Document the MAC addresses of the switch ports.
Answer: AB

QUESTION NO: 92
Which two statements are true about voice VLANs? (Choose two.)
A. Voice VLANs are only used when connecting an IP phone and a host to distinct switch ports.
B. Access ports that are configured with voice VLANs will always trust the CoS that is received from IP phones.
C. Access ports that are configured with voice VLANs may or may not override the CoS value that is received from an IP phone.
D. Voice VLANs are configured using the switchport voice vlan vlan-ID interface configuration command.
E. Voice VLANs provide a trunking interface between an IP phone and an access port on a switch to allow traffic from multiple devices that are connected to the port.
F. Enabling Voice VLAN on a switch port will automatically configure the port to trust the incoming CoS markings.
Answer: CD

QUESTION NO: 93
Which of the following should you enable to prevent a switch from forwarding packets with source addresses that are outside an administratively defined group? (Select the best answer.)
A. DAI
B. STP
C. PVLAN
D. port security
Answer: D

QUESTION NO: 94
Refer to the exhibit. Which statement is true about the display of the command show pagp 1 neighbor command?
94
A. STP packets are sent out the Gi0/1 interface only.
B. STP packets are sent out both the Gi0/1 and Gi0/2 interfaces.
C. CDP packets are sent out the Gi0/1 interface only.
D. CDP packets are sent out the Gi0/2 interface only.
Answer: A

QUESTION NO: 95
95
You administer the network shown above. You issue the show interfaces trunk command on SwitchA and receive the following output:
SwitchA#show interfaces trunk Port Mode Encapsulation Status Native vlan Fa0/1 desirable -n802.1q trunking 1 Port Vlans allowed on trunk Fa0/1 1-4094 Port Vlans allowed and active in management domain Fa0/1 1-9,31-37 Port Vlans in spanning tree forwarding state and not pruned Fa0/1 1-9,31,33-37
Which of the following statements is true regarding VLAN 32? (Select the best answer.)
A. VLAN 32 is not allowed on the trunk port.
B. VLAN 32 is not active on the switch.
C. Traffic from VLAN 32 is not being sent over the trunk port.
D. Traffic from VLAN 32 is not restricted to only the trunk ports that require it.
Answer: C

One thought on “642-813 Q&A – Mix Practice Questions (91-95)

Comments are closed.