Home » Archive by category SWITCH 642-813 Q&As

642-813 Q&A – New Questions (26-30) (March, 2012)

Section 7 – New Questions (March, 2012) QUESTION 26 You are tasked with designing a security solution for your network. What information should be gathered prior to designing the solution? A.    a list of applications currently in use in the network B.    IP addressing design plans so that...
Continue reading
Section 7 - New Questions (March, 2012), SWITCH 642-813 Q&As

642-813 Q&A – New Questions (21-25) (March, 2012)

Section 7 – New Questions (March, 2012) QUESTION 21 Which of the following will generate an RSTP topology change notification? (Select the best answer.) A.    an edge port that transitions to the forwarding state B.    a non-edge port that transitions to the blocking state C.    a non-edge port...
Continue reading
Section 7 - New Questions (March, 2012), SWITCH 642-813 Q&As

642-813 Q&A – New Questions (16-20) (March, 2012)

Section 7 – New Questions (March, 2012) QUESTION 16 Which optional feature of an Ethernet switch disables a port on a point-to-point link if the port does not receive traffic while Layer 1 status is up? A.    BackboneFast B.    UpLinkFast C.    Loop Guard D.    UDLD aggressive mode E.   ...
Continue reading
Section 7 - New Questions (March, 2012), SWITCH 642-813 Q&As

642-813 Q&A – New Questions (11-15) (March, 2012)

Section 7 – New Questions (March, 2012) QUESTION 11 Which two statements are true about best practices in VLAN design? (Choose two.) A.    Routing should occur at the access layer if voice VLANs are utilized. Otherwise, routing should occur at the distribution layer. B.    Routing may be performed...
Continue reading
Section 7 - New Questions (March, 2012), SWITCH 642-813 Q&As

642-813 Q&A – New Questions (6-10) (March, 2012)

Section 7 – New Questions (March, 2012) QUESTION 6 In the event that two devices need access to a common server, but they cannot communicate with each other, which security feature should be configured to mitigate attacks between these devices? A.    port security B.    dynamic ARP inspection C.   ...
Continue reading
Section 7 - New Questions (March, 2012), SWITCH 642-813 Q&As

642-813 Q&A – New Questions (1-5) (March, 2012)

Section 7 – New Questions (March, 2012) QUESTION 1 Refer to the exhibit. If VLAN 21 does not exist before typing the commands, what is the result of the configuration applied on switch SW1? A.    A new VLAN 21 is created and port 0/8 is assigned to that...
Continue reading
Section 7 - New Questions (March, 2012), SWITCH 642-813 Q&As 642-813 Q&A Index, SWITCH 642-813 Q&As Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As

642-813 Q&A – Mix Practice Questions (171-175)

Section 6 – Mix Practice Questions QUESTION NO: 171 What must be the same to make multiple switches part of the same Multiple Spanning Tree (MST)? A. VLAN instance mapping and revision number B. VLAN instance mapping and member list C. VLAN instance mapping, revision number, and member...
Continue reading
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As

642-813 Q&A – Mix Practice Questions (166-170)

Section 6 – Mix Practice Questions QUESTION NO: 166 Refer to the exhibit. Which two statements are true? (Choose two.) A. It is displaying the AutoQos configuration that was initially applied. B. The switch does not trust the CoS values of a Cisco IP phone attached to port...
Continue reading
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As

642-813 Q&A – Mix Practice Questions (161-165)

Section 6 – Mix Practice Questions QUESTION NO: 161 Which two statements are true about voice packets in a LAN? (Select two) A. Voice traffic data flow involves large volumes of large packets. B. Because a packet loss involves a small amount of data, voice traffic is less...
Continue reading
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As

642-813 Q&A – Mix Practice Questions (156-160)

Section 6 – Mix Practice Questions QUESTION NO: 156 What are three results of issuing the switchport host command? (Choose three.) Select 3 response(s). A. disables EtherChannel B. enables port security C. disables Cisco Discovery Protocol D. enables PortFast E. disables trunking F. enables loopguard Answer: ADE
Continue reading
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As

642-813 Q&A – Mix Practice Questions (151-155)

Section 6 – Mix Practice Questions QUESTION NO: 151 You are adding an additional LAP to your current wireless network, which uses LWAPP. The LAP is configured with a static IP address. Which of the following steps is the first step when the LAP attempts to register with...
Continue reading
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As

642-813 Q&A – Mix Practice Questions (146-150)

Section 6 – Mix Practice Questions QUESTION NO: 146 What two things will occur when an edge port receives a BPDU? (Choose two.) A. The port immediately transitions to the Forwarding state. B. The switch generates a Topology Change Notification (TCN) BPDU. C. The port immediately transitions to...
Continue reading
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As

642-813 Q&A – Mix Practice Questions (141-145)

Section 6 – Mix Practice Questions QUESTION NO: 141 You want to enhance the security within the Pass4sure LAN and prevent VLAN hopping. What two steps can be taken to help prevent this? (Select two) A. Enable BPD guard B. Disable CDP on ports where it is not...
Continue reading
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As

642-813 Q&A – Mix Practice Questions (126-130)

Section 6 – Mix Practice Questions QUESTION NO: 126 Which of the following are functions that are often provided by an ITSP but are not typically provided by the PSTN? (Select 2 choices.) A. QoS B. call setup and teardown C. call routing D. call supervision E. audio...
Continue reading
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As
Pages:  1 2 3 4 5 6