Home »
Archive by category SWITCH 642-813 Q&As (Page 2)
Section 6 – Mix Practice Questions QUESTION NO: 121 You want to configure a switched internetwork with multiple VLANs as shown above. Which of the following commands should you issue on SwitchA for the port connected to SwitchB? (Select the best answer.)
Continue reading
August 24, 2011 admin
642-813 Q&A Index, Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As
Section 6 – Mix Practice Questions QUESTION NO: 116 Refer to the exhibit. What does the command channel-group 1 mode desirable do? A. enables LACP unconditionally B. enables PAgP only if a PAgP device is detected C. enables PAgP unconditionally D. enables Etherchannel only E. enables LACP only...
Continue reading
August 23, 2011 admin
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As
Section 6 – Mix Practice Questions QUESTION NO: 111 Refer to the exhibit. On the basis of the output of the show spanning-tree inconsistentports command, which statement about interfaces FastEthernet 0/1 and FastEthernet 0/2 is true?
Continue reading
August 19, 2011 admin
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As
Section 6 – Mix Practice Questions QUESTION NO: 106 Which of the following HSRP router states does an active router enter when it is preempted by a higher priority router? (Select the best answer.) A. active B. speak C. learn D. listen E. init F. standby Answer: B
Continue reading
August 18, 2011 admin
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As
Section 6 – Mix Practice Questions QUESTION NO: 101 Refer to the exhibit. Three different wireless groups of users are allowed to gain access to the wireless LAN. What type of security policy should be enforced for the users in the Guest group?
Continue reading
August 17, 2011 admin
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As
Section 6 – Mix Practice Questions QUESTION NO: 96 You have just created a new VLAN on your network. What is one step that you should include in your VLAN-based implementation and verification plan? A. Verify that trunked links are configured to allow the VLAN traffic. B. Verify...
Continue reading
August 15, 2011 admin
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As
Section 6 – Mix Practice Questions QUESTION NO: 91 Which two of the following steps are necessary to configure inter-VLAN routing between multilayer switches? (Choose two.) A. Configure a dynamic routing protocol. B. Configure SVI interfaces with IP addresses and subnet masks. C. Configure switch ports with network...
Continue reading
August 14, 2011 admin
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As
Section 6 – Mix Practice Questions QUESTION NO: 86 Which two statements best describe Cisco IOS IP SLA? (Choose two.) A. only implemented between Cisco source and destination-capable devices B. statistics provided by syslog, CLI, and SNMP C. measures delay, jitter, packet loss, and voice quality D. only...
Continue reading
August 14, 2011 admin
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As
Section 6 – Mix Practice Questions QUESTION NO: 81 Refer to the exhibit. Which statement is true? A. IP traffic matching access list ABC is forwarded through VLANs 5-10. B. IP traffic matching VLAN list 5-10 will be forwarded, and all other traffic will be dropped. C. All...
Continue reading
July 24, 2011 admin
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As
Section 6 – Mix Practice Questions QUESTION NO: 76 Which three statements about STP timers are true? (Choose three.) A. STP timers values (hello, forward delay, max age) are included in each BPDU. B. A switch is not concerned about its local configuration of the STP timers values....
Continue reading
July 11, 2011 admin
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As
Section 6 – Mix Practice Questions QUESTION NO: 71 Which of the following is not information provided from an IP phone to a Catalyst switch using CDP? (Select the best answer.) A. device PoE requirements B. device IP address C. device voice VLAN ID D. device platform Answer:...
Continue reading
June 27, 2011 admin
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As
Section 6 – Mix Practice Questions QUESTION NO: 66 Which two statements are true about a switched virtual interface (SVI)? (Select two) A. An SVI is normally created for the default VLAN (VLAN1) to permit remote switch administration. B. Multiple SVIs can be associated with a VLAN. C....
Continue reading
June 16, 2011 admin
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As
Section 6 – Mix Practice Questions QUESTION NO: 61 What is the effect of configuring the following command on a switch? Switch(config)# spanning-tree portfast bpdufilter default A. If BPDUs are received by a port configured for PortFast, then PortFast is disabled and the BPDUs are processed normally. B....
Continue reading
May 29, 2011 admin
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As
Section 6 – Mix Practice Questions QUESTION NO: 56 What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals? A. RSTP information is automatically aged out. B. The port...
Continue reading
May 29, 2011 admin
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As
Section 6 – Mix Practice Questions QUESTION NO: 51 Which two items are most important for managing the long-term success of high availability? (Choose two.) A. completing aggressive implementation schedule B. Stateful Switchover C. company and user expectations D. Nonstop Forwarding E. change control processes F. dual devices...
Continue reading
May 10, 2011 admin
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As
Section 6 – Mix Practice Questions QUESTION NO: 46 Which two statements about a wireless repeater topology are true? (Choose two.) A. A wireless repeater is an access point that is not connected to the wired LAN. B. The repeater feature is only available in lightweight access point...
Continue reading
May 10, 2011 admin
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As
Section 6 – Mix Practice Questions QUESTION NO: 41 By itself, what does the command aaa new-model enable? A. It globally enables AAA on the switch, with default lists applied to the VTYs. B. Nothing; you must also specify which protocol (RADIUS or TACACS) will be used for...
Continue reading
May 9, 2011 admin
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As
Section 6 – Mix Practice Questions QUESTION NO: 36 Refer to the exhibit. Which of these is true based upon the output shown in the command?
Continue reading
May 9, 2011 admin
Section 6 - Mix Practice Q&As, SWITCH 642-813 Q&As
