Home »
Archive by category SWITCH 642-813 Q&As (Page 4)
Section 5 – Implement High Availability, given a network design and a set of requirements QUESTION NO: 11 On a 3550 EMI switch, which three types of interfaces can be used to configure HSRP? (Choose three.) A.loopback interface B.SVI interface C.routed port D.access port E.EtherChannel port channel F.BVI...
Continue reading
April 19, 2011 admin
Section 5 - High Availability, SWITCH 642-813 Q&As
Section 5 – Implement High Availability, given a network design and a set of requirements QUESTION NO: 6 Which one of the statements below correctly describes the Virtual Router Redundancy Protocol (VRRP), which is being used in the Pass4sure network to provide redundancy? A. A VRRP group has...
Continue reading
April 18, 2011 admin
Section 5 - High Availability, SWITCH 642-813 Q&As
Section 5 – Implement High Availability, given a network design and a set of requirements QUESTION NO: 1 In which three HSRP states do routers send hello messages? (Choose three.) A.standby B.learn C.listen D.speak E.active Answer: A D E
Continue reading
April 18, 2011 admin
Section 5 - High Availability, SWITCH 642-813 Q&As
Section4 – Prepare infrastructure to support advanced services • Implement a Wireless Extension of a Layer 2 solution • Implement a VoIP support solution • Implement video support solution
Continue reading
April 15, 2011 admin
642-813 Q&A Index, SWITCH 642-813 Q&As
Section4 – Prepare infrastructure to support advanced services QUESTION NO: 81 What is the function of the Service Set Identifier (SSID) in the wireless LAN? A. The SSID should be configured on the client site only and provides data-privacy functions and authentication to the access point. B. The...
Continue reading
April 15, 2011 admin
Section 4 - Prepare Infrastructure, SWITCH 642-813 Q&As
Section4 – Prepare infrastructure to support advanced services QUESTION NO: 76 Which three statements are true about the voice VLAN feature on a Catalyst 2950 switch? (Choose three.) A.The CoS value is trusted for 802.1p or 802.1q tagged traffic. B.The voice VLAN feature is disabled by default. C.The...
Continue reading
April 14, 2011 admin
Section 4 - Prepare Infrastructure, SWITCH 642-813 Q&As
Section4 – Prepare infrastructure to support advanced services QUESTION NO: 71 A Cisco IP phone connects to a host PC and a switch as shown below:
Continue reading
April 14, 2011 admin
Section 4 - Prepare Infrastructure, SWITCH 642-813 Q&As
Section4 – Prepare infrastructure to support advanced services QUESTION NO: 66 Jitter is causing problems with the VOIP application in the Pass4sure network. What causes network jitter? A. Variable queue delays B. Packet drops C. Transmitting too many small packets D. Compression Answer: A
Continue reading
April 13, 2011 admin
Section 4 - Prepare Infrastructure, SWITCH 642-813 Q&As
Section4 – Prepare infrastructure to support advanced services QUESTION NO: 61 Refer to the exhibit. Which switch interface configuration command would automatically configure quality of service (QoS) for voice over IP (VoIP) within a QoS domain?
Continue reading
April 13, 2011 admin
Section 4 - Prepare Infrastructure, SWITCH 642-813 Q&As
Section4 – Prepare infrastructure to support advanced services QUESTION NO: 56 Refer to the exhibit. Which Catalyst switch interface command would be used to cause the switch to instruct the phone to override the incoming CoS from the PC before forwarding the packet to the switch?
Continue reading
April 12, 2011 admin
Section 4 - Prepare Infrastructure, SWITCH 642-813 Q&As
Section4 – Prepare infrastructure to support advanced services QUESTION NO: 51 Which two statements are true about trust boundaries? (Choose two.) A. Setting trust boundaries at the edge of the network allows intermediate hop devices to administer QoS policies without detailed packet identification. B. Trust boundaries are used...
Continue reading
April 12, 2011 admin
Section 4 - Prepare Infrastructure, SWITCH 642-813 Q&As
Section4 – Prepare infrastructure to support advanced services QUESTION NO: 46 VOIP is being implemented in the Pass4sure network and you need to assess the need for QoS. Which of the following network problems would indicate a need to implement QoS features? (Select three) A. Mis-routed packets B....
Continue reading
April 11, 2011 admin
Section 4 - Prepare Infrastructure, SWITCH 642-813 Q&As
Section4 – Prepare infrastructure to support advanced services QUESTION NO: 41 Which two Lightweight Access Point Protocol (LWAPP) statements are true? (Choose two.) A. Control traffic is encapsulated in UDP packets with a source port of 1024 and a destination port of 12223. B. Control traffic is encapsulated...
Continue reading
April 11, 2011 admin
Section 4 - Prepare Infrastructure, SWITCH 642-813 Q&As
Section4 – Prepare infrastructure to support advanced services QUESTION NO: 36 Refer to the exhibit. Which statement is true about the voice traffic coming to the switch access port that is connected to the IP phone?
Continue reading
April 7, 2011 admin
Section 4 - Prepare Infrastructure, SWITCH 642-813 Q&As
Section4 – Prepare infrastructure to support advanced services QUESTION NO: 31 What are three functions of the Cisco wireless LAN controller, which is being used in the Centralized WLAN solution network? (Select three) A. Authentication B. Mobility C. Security management D. Transmission of beacon frames E. Real-time portions...
Continue reading
April 7, 2011 admin
Section 4 - Prepare Infrastructure, SWITCH 642-813 Q&As
Section4 – Prepare infrastructure to support advanced services QUESTION NO: 26 Refer to the exhibit. Which two statements are true about the required switch configurations to support a voice VLAN? (Choose two.)
Continue reading
April 6, 2011 admin
Section 4 - Prepare Infrastructure, SWITCH 642-813 Q&As
Section4 – Prepare infrastructure to support advanced services QUESTION NO: 21 Network topology exhibit:
Continue reading
April 6, 2011 admin
Section 4 - Prepare Infrastructure, SWITCH 642-813 Q&As
Section4 – Prepare infrastructure to support advanced services QUESTION NO: 16 Which statement is true about the Lightweight Access Point Protocol (LWAPP)? A. The control traffic between the client and the access point is encapsulated with the LWAPP. B. Data traffic between the client and the access point...
Continue reading
April 1, 2011 admin
Section 4 - Prepare Infrastructure, SWITCH 642-813 Q&As
