Home » SWITCH 642-813 Q&As » Archive by category Section 7 – New Questions (March, 2012)

642-813 Q&A – New Questions (26-30) (March, 2012)

Section 7 – New Questions (March, 2012) QUESTION 26 You are tasked with designing a security solution for your network. What information should be gathered prior to designing the solution? A.    a list of applications currently in use in the network B.    IP addressing design plans so that...
Continue reading
Section 7 - New Questions (March, 2012), SWITCH 642-813 Q&As

642-813 Q&A – New Questions (21-25) (March, 2012)

Section 7 – New Questions (March, 2012) QUESTION 21 Which of the following will generate an RSTP topology change notification? (Select the best answer.) A.    an edge port that transitions to the forwarding state B.    a non-edge port that transitions to the blocking state C.    a non-edge port...
Continue reading
Section 7 - New Questions (March, 2012), SWITCH 642-813 Q&As

642-813 Q&A – New Questions (16-20) (March, 2012)

Section 7 – New Questions (March, 2012) QUESTION 16 Which optional feature of an Ethernet switch disables a port on a point-to-point link if the port does not receive traffic while Layer 1 status is up? A.    BackboneFast B.    UpLinkFast C.    Loop Guard D.    UDLD aggressive mode E.   ...
Continue reading
Section 7 - New Questions (March, 2012), SWITCH 642-813 Q&As

642-813 Q&A – New Questions (11-15) (March, 2012)

Section 7 – New Questions (March, 2012) QUESTION 11 Which two statements are true about best practices in VLAN design? (Choose two.) A.    Routing should occur at the access layer if voice VLANs are utilized. Otherwise, routing should occur at the distribution layer. B.    Routing may be performed...
Continue reading
Section 7 - New Questions (March, 2012), SWITCH 642-813 Q&As

642-813 Q&A – New Questions (6-10) (March, 2012)

Section 7 – New Questions (March, 2012) QUESTION 6 In the event that two devices need access to a common server, but they cannot communicate with each other, which security feature should be configured to mitigate attacks between these devices? A.    port security B.    dynamic ARP inspection C.   ...
Continue reading
Section 7 - New Questions (March, 2012), SWITCH 642-813 Q&As

642-813 Q&A – New Questions (1-5) (March, 2012)

Section 7 – New Questions (March, 2012) QUESTION 1 Refer to the exhibit. If VLAN 21 does not exist before typing the commands, what is the result of the configuration applied on switch SW1? A.    A new VLAN 21 is created and port 0/8 is assigned to that...
Continue reading
Section 7 - New Questions (March, 2012), SWITCH 642-813 Q&As